Flowserve’s Byron Jackson H2O+ Submersible Pump

07 September 2021

Flowserve’s new Byron Jackson H2O+ submersible pump range promises to meet the requirements for high efficiency and extended lifecycles of deep well submersibles. Designed with a rugged construction, the Byron Jackson H2O+ is built with heavy-duty castings that are capable of withstanding sand and debris, which can degrade performance and accelerate wear on pump components. In addition, long-lasting rubber bearings and composite wear rings extend pump life while water-lubricated, carbon radial bearings reduce internal heat generation and maximize efficiency. 

The Byron Jackson H20+ boasts a broad hydraulic coverage that meets nearly any duty condition requirement. The water-filled, wet-wound motors are highly efficient, reliable, and environmentally friendly. The motor comes with a standard integral check valve to protect the motor thrust bearing system and the water-tight insulated windings ensure easy service, improve cooling and extend motor life. The rewindable motors feature high-quality PE2+PA (polyethylene and polyamide) winding wire insulation that enables higher-temperature operation of up to 55°C (131°F). 

The Byron Jackson H20+ is NSF certified for drinking water and ideal for deep-well water applications in standard DN 150 — DN250 (6, 8, and 10 inch) sizes. It can deliver a maximum flow rate of 6,000 m3 /h (26,415 gpm) and heads up to 800 m (2,625 ft). 

Image credit: Flowserve